Name | Capacitive level indicator |
---|---|
Type | SCP30 D ACDC AYC – ref: 2802-0-021 |
Supply voltage | 20 – 280 V AC/DC |
Output type | NA or NC according to selector |
Current output | 500 mA |
Maximum voltage drop | < 6 V AC RMS / V DC |
Maximum ondulation | 5 % |
Sensitivity | Adjustable 0 – 20 mm depending on the material. Pre-adjusted to detect grain |
Product temperature | -20° C – +70° C |
Protection | IP69K according to DIN 40050-9 |
Weight | 0,29 Kg |
Cable output | 2 wires x 2 meters |
Materials: | |
Housing | PBT |
Cable | Double isolation PVC |
Accesory (under request) | M30: Delrin Pg 29: PVC |
- Productos
- Best selling solids and liquids controllers
- SCP 30 D ACDC AYC
Intended use
The capacitive levels indicators SCP 30 D ACDAC AYC are to be used to control the maximum or minimum level of liquid like water, oil, chemical products, etc., in tanks or recipients or control the maximum or minimum level of bulk solids like feed, cereal, grain, etc., in silos or vessels. These devices also control the flow of these materials in pipes or are to be used to detect conductive or non-conductive materials through non-conductive walls.
The output of the devices is protected against overloads and short-circuits. Due to the encapsulation of the controllers, the devices are immune to noise or electrical interferences from mobiles, motors, etc.
Function
When the level of product reaches the controller, the electronic unit reverses the signal due to a change of the capacity of the environment. When the product disappears from the detection range, the signal turns to the initial position.
Mechanical connection
The standard form is mounting the device with the nuts or with the mounting accessory under request.
Drill a Ø 30 mm hole into the tank or silo wall, polish it, place the device and fixing it with the nuts or screw it into a flange or into an appropriate support to fix it.
If the mounting is made with the mounting accessory, drill a G 1 " 1/4 hole into the tank or silo wall, fix the accessory and screw the device on it. Under request, there are Galvanized or Stainless Steel G 1" 1/4 nuts to fix the accessory to the interior of the wall as counter-nut.