Name | Capacitive level indicator |
---|---|
Type | SCP 30 ACDC – ref: 2803-0-001 |
Supply voltage | 20 – 250 V AC (50 – 60 Hz) 20 – 250 V DC |
Output type | NO or NC depending on the selector |
Current output | 200 mA |
Maximum voltage drop | < 10 V AC, < 8 V DC |
Maximum ondulation | < 10 % |
Sensitivity | Adjustable 0 – 20 mm depending on the material. Pre-adjusted to detect grain |
Product temperature | -25° C – +70° C |
Protection | IP67 according to DIN EN60529 |
Weight | 0,27 Kg |
Cable output | Connector M12, with a cable of 2 wires x 2 meters |
Materials: | |
Housing | Reinforced plastic |
Cable | Double isolation PVC |
Accesory (under request) | PVC |
Intended use
Simple model with 2 wires cable connection output, with connector M12, threaded body and NO or NC output selection. A load must be connected por a proper use.
The capacitive levels indicators SCP 30 ACDC are to be used to control the maximum or minimum level of liquid like water, oil, chemical products, etc., in tanks or recipients or control the maximum or minimum level of bulk solids like feed, cereal, grain, etc., in silos or vessels. These devices also control the flow of these materials in pipes or are to be used to detect conductive or non-conductive materials through non- conductive walls.
The output of the devices are protected against overloads and short- circuits. Due to the encapsulation of the controllers, the devices are immune to noise or electrical interferences from mobiles, motors, etc.
Function
When the level of product reaches the controller, the electronic unit reverses the signal due to a change of the capacity of the environment. When the product disappear from the detection range, the signal turns to the initial position.
Mechanical connection
The standard form is mounting the device with the nuts or with the mounting accesory under request.
Drill a Ø 30 mm hole into the tank or silo wall, polish it, place the device and fixing it with the nuts or screw it into a flange or into an appropiate support to fix it.
If the mounting is made with the mounting accesory, drill a G 1 " 1/4 hole into the tank or silo wall, fix the accesory and screw the device on it. Under request there are Galvanized or Stainless Steel G 1 " 1/4 nuts to fix the accesory to the interior of the wall as counter-nut.