ICS-V

Capacitive level indicators
Control of solids

Intended use

Model for vertical mounting with rope shaft and to have an electronic remote installation. The capacitive levels indicators ICC-V are to be used to control the maximum or minimum level of bulk solids in silos or vessels.

The model ICSC-V has a Stainless Steel cable rope that can be Polypropylene recovered under request and a Stainless Steel counterweight probe. The devices can have a rope shaft up to 15.000 mm length depending of the product to control.

This model has a insensitive rod between the probe and the proccess connection to avoid the possibility of settle of the product over the probe and false signals. It is not recommended for sticky solids or products that have the tendency to settle over probe.

Function

The probe must to be exposed to the material. When the level of product reaches the rod, the control unit ICU reverses the signal due to a change of the capacity of the environment.
When the product disappear from the detection range, the signal turns to the initial position.

The control unit ICU has a regulation system that allow the adjustment of the sensitivity and a response time adjustment due to a nut in the electronic module.

Mechanical connection

The device has to be mounted vertically.

The normal installation is by screwing the device onto the deposit wall, with a mounting flange or with an appropiate support to fix it.

Dimensions

Approximate measures given in mm.

Technical data


Name	Capacitive level indicator
Type	ICS-V – ref: 2150-0-001 ICS-V rec. PP – ref: 2150-0-002
Supply voltage	Connected at unit control ICU
Maximum voltage ICS & ICS-V	18 V DC
Cable entry	DIN 43650 connector
Product temperature	-10° C – +70° C (Under request up to 150 ºC)
Ambient temperature	-10° C – +60° C
Protection	IP65 according to DIN EN60529
Weight	1,40 Kg depending on the model
Materials:
Housing	Polypropylene
Rod	Stainless Steel 1.4305
Rod cover	PTFE
Cable	Stainless Steel (Under request Polypropylene recovered)