Name | Capacitive level indicator |
---|---|
Type | ICC-V – ref: 2161-...-001 ICC-V rec. PP – ref: 2161-...-002 |
Supply voltage | |
2161-230-001 y 2161-230-002 | 230 V AC (50 – 60 Hz) |
2161-115-001 y 2161-115-002 | 115 V AC (50 – 60 Hz) |
2161-024-001 y 2161-024-002 | 24 V AC (50 – 60 Hz) |
2161-2122-001 y 2161-2122-002 | 12 – 35 V DC |
Power consumption | 1 VA |
Cable entry | 2 de M20x1,5 |
Relay output | 1 NA + 1 NC 1 A / 250 V AC |
Function status | Under voltage: green LED Relay enabled: red LED |
Product temperature | -10° C – +90° C (Under request up to +150º C) |
Ambient temperature | -10° C – +60° C |
Protection | IP65 according DIN EN60529 |
Weight | 1,40 Kg depending on the model |
Materials: | |
Housing | Polycarbonate |
Rod | Stainless Steel 1.4035 |
Rod cover | PTFE |
Cable | Stainless Steel (Under request Polypropylene recovered) |
Intended use
Model for vertical mounting with rope shaft. The capacitive levels indicators ICC-V are to be used to control the maximum or minimum level of bulk solids in silos or vessels.
The model ICC-V has a Stainless Steel cable rope that can be Polypropylene recovered under request and a Stainless Steel counterweight probe. The devices can have a rope shaft up to 15.000 mm length depending of the product to control.
This model has a insensitive rod between the probe and the proccess connection to avoid the possibility of settle of the product over the probe and false signals. It is not recommended for sticky solids or products that have the tendency to settle over probe.
Function
The probe must to be exposed to the material. When the level of product reaches the rod, the control unit reverses the signal due to a change of the capacity of the environment.
When the product disappear from the detection range, the signal turns to the initial position.
These devices have inside the housing a regulation system that allow the adjustment of the sensitivity due to a nut in the electronic module.
Mechanical connection
The device has to be mounted vertically.
The normal installation is by screwing the device onto the deposit wall, with a mounting flange or with an appropiate support to fix it.