Standard model for vertical mounting with Stainless Steel 1.4401 body, total length 48 mm, S.S. Ø 30x30 mm float, 1 NO contact reversible to NC, with thread process connection to mount the device from the inside of the tank and with cable output.

These devices are used to control the level in tanks, containers, bypass pipes, ... of liquids like waters, oils, chemical products, ... with non-ferric particles in suspension are used. This model is specially indicated to be control the maximum, minimum or an alarm level in small tanks.

The magnetic float switch BC-30 has a guide-way body where a float moves. Inside the body there is a REED contact that change its position due to the magnetic field of the magnet placed inside the float when arrives at the contact point. When the liquid level falls, the float moves back and the signal turns into the initial position. To reverse the NO contact to NC contact, take the float out and change the position 180º.

The standard form is mounting the device with the thread proccess connection. Drill a hole in the top of the tank or container, polish it to prevent damage and introduce the cable from inside and place the group to the wall verifying the position of the device. Keep the position of the group and tigthen the nut, verify the position of the indicator and connect the cable to the system of control.

Depending on the application, the indicator can be mounted from the bottom of the tank or container (facing down).

For a correct use of the level switch, the float must not touch the walls of the tank and it is necessary to ensure the free movement of the float.


Approximate measures given in mm.

Technical data

NameMagnetic float switch
TypeBC-30 – ref: 2510-1
Body length48 mm
Body diameterØ 8 mm
Number of contacts1
ContactsNO (NC reversing the float)
Position of the contactsMinimum
Capacity of the contact20 W, 0.5 A, 230 V AC (for resistive loads)
For inductive or capacitive loads reduce at 50%
Electrical output1 meter cable
Thread Proccess connectionG 1/8”
FloatØ 30x30 mm
Product density0,8 Kg/l
ProtectionIP65 according DIN EN60529 with Epoxy resin protection, non-removable contact
Maximum pressure+15 bar
Maximum temperature+120º C
BodyStandard Stainless Steel 1.4401
FloatStandard Stainless Steel 1.4401
Mechanical stopsStandard Stainless Steel 1.4401
CableDouble insulation Silicone

Explore all our level controls

Need more information?